Recent content by v6viking

SOLD!!!!!!!! For sale: Ross Tech VCDS Micro CAN Cable Purchased 4/2011 and used a handful of times. I sold the GTI in July and no longer need this cable. Works perfectly. Originally paid $268.69 including shipping, will take $200.00, shipping included. PM or email with any questions...

SOLD!!! For Sale: SPM Steve Petty Motorsports MK6 2.0T Stainless Steel 3 Inch “Street Edition” Down Pipe. Excellent Condition, used for approximately 6 Months. Only selling because I sold the car. Would prefer not to ship if possible. Local Pick up in Seaford or Melville, NY. Sells for...

SOLD!!! For sale: Modshack GTI VTDA in Charcoal Metallic - Engine Trim Strip: Black Excellent Condition; comes with everything you need. The filter was just cleaned and re-oiled, and is ready to be installed. Only selling because I sold the car. Paid $265.00 including shipping, will...

SOLD!!!!!!!!!!!! New in package, never Installed. I used different o2 spacers on my setup. Purchased for $84.30 including shipping, will take $60.00, shipping included. PM or email with any questions. Thanks, Matt v6viking@aol.com

SOLD!!! Paid $129.59 including shipping, will take $100.00, shipping included. High Resolution Pics available. PM or email with any questions. Thanks, Matt v6viking@aol.com

Sold!! Excellent Condition. Used in my car for approximately 7 months. Traded in the VW in July; selling off my stuff. Currently sells for $200 including shipping, will take $125.00, shipping included. Wiring from gauge has been trimmed but is still long enough to reach the light...

I traded in the GTI for an Audi A5 and my Micro Can Cable is not compatible. I now need the Hex Can cable. Please PM me or reply if you'd like to sell your HEX+CAN cable. Trade + cash for my Micro Can will be considered also. Thanks! -Matt PS: SPM DP, RAI Jets (unused) and Modshack...

Been having an acceleration issue where the car will not pull over 4500-5500 rpm, but no codes are being thrown. The video below shows the problem. (CEL is on in the video due to a faulty intake. It has been replaced, and there have been no codes for 250 miles.) When I did my datalogging, the...

Mods are shown below. I currently have the following codes: 2 Faults Found: 008213 - Intake Manifold Flap Position Sensor (Bank 1) P2015 - 000 - Implausible Signal - MIL ON Freeze Frame: Fault Status: 11100000 Fault...

My apologies if this is old news...it's new to me!! http://jalopnik.com/5850855/howd-the-virginia-dmv-let-this-dirty-license-plate-slip-by

:word:

My wife bought me the New South Boost Gauge and Vent Pod from ECS Tuning, and a full detailing from the local detailer!! :thumbsup: How about everyone else??

Bwahahahahaha :bellyroll:

I wanted to install one on the boat, but those setups don't come cheap!!