Am I the only one in the universe that has no issues whatsoever removing the top inside nut...?
I just normally go from above the heat shield with a swivel ratchet and no extensions etc...
~~ 19th Oct '16~~
Guess who's back?
Installed: VMR V804 18x8 et42 (18.8lbs each) in hyper silver
Installed: Snow performance stage 2 water meth kit:
- Dual injection, 100cc/min post fmic and 175cc/min post tb
- Tune: 95RON fuel with 102RON file (it's like a 98oct+ file for euro spec)
-...
Hello,
I have a stage 2 Snow kit (SKU 210) purchased direct from Snow and installed on my 2010 MK6 GTI and the engine sometimes idles low rpm and dies at startups, sometimes I can rev it to have it start normally.
My setup consists of 2 nozzles, one post throttle body (100cc/min) and the other...
Gas pressure is spot on and the fans running fine plus no faults.
Bad compressor? Any experiences?
PS car has 87k miles on it.
Sent from my iPhone using Tapatalk
This started recently and looking for people that experienced it.
When the car gets hot, the rattle from the pulleys side starts around 1k rpm and gets louder as RPM increases. Power doesn't seem to be affected.
- I do hear some knock at some incidences when it gets too hot outside and rattle...
Hi,
Got small dent in the middle of the door plus one to the front close to the fender..
How to fix this? I know that removing the inner skin doesn't give you access...anyone got this done?
Hello,
I crashed my car and needing new headlights..
Anyone have these? work fine? how is the brightness of the LEDs?
https://www.ecstuning.com/Search/SiteSearch/Winpower/ES2960917/
I have a full resonated UR TB (resonated downpipe, resonated cutback, rear mufflers) and the drone between 2k and 3k is insane.
The interior vibrates around, I hate pushing this car with the windows closed..
What can I do about this to eliminate the drone without going stock (duh)?
Now that the BSH pipe doesn't have a mount, how is fitment?
Feedback from the owners of the new design is appreciated. :thumbsup:
Thinking of buying this to make use of the methanol bung.
Mods:
Bilstein B14 coilovers
034 Street Density strut mounts
Tyrolsport subframe stiffening kit
Superpro anti lift kit
all new suspension hardware
Superpro control arm bushings
I had this noise on my previous coilovers, it went away when I switched to B14 then it cam back again..
When I...
I noticed that 5 out of the 10 bolts have stripped threads and can't be torqued down..
Anyone tried using Loctite thread locker or similar?
It's just a small hole with 11NM torque, so I though a simple fix like this might work..
Acceleration from low rpm in a high gear towards redline, I hear a metallic rattle from the right side of the engine bay that sounds like the stock turbo wastegate rattle.
Doesn't happen in idle, car behaves normally and no loss of power, logs show normal operation as well.
Any clue or...